Mustang K-Member Installation
- Jack up car and support with jack stand behind K-member on frame rails
- If motor is still using stock mounts and motor is still in the car, support motor with an engine hoist
- Place jack under lower A-arm. Carefully remove spindle from the ball joint
- Lower jack slowly. (CAUTION: Spring will still have tension, carefully remove spring with pry bar)
- Remove rack, pinion and steering shaft.
- Remove motor mount nuts or bolts.
- Place jack under center of K-member. Then remove the 8 bolts that attach K-member to frame. Lower Jack.
- Start installing bolts back into your AJE K-member. Start with driver side front and passenger side front to square K-member in car. Install all bolts in K-member before tightening.
- Reinstall the rest of your front suspension in opposite order of removal
- A-Arms location have slip bushings that close the gaps on a-arms by tightening bolts
When K-member is shipped with control arms, control arm bolts will need to be tightened after K-member is installed. When installation is complete grease ball joints.